FENDER TWIN REVERB II

FENDER TWIN REVERB II

1983-1986 

Configuration: Combo, Head
Power: 105 Watts
Effects: Reverb

SCHEMATIC

LAYOUT

  • Front Panel: In, In, Volume (Pull for Bright), Treble, Middle, Bass - Volume (Pull for Channel Select), Gain, Master Volume, Treble, Middle (Pull for Boost), Bass, Reverb, Presence - Standby Switch, Power Switch, Pilot Light
  • Back Panel: Fuse, AC Outlet, Ground Switch, Speaker Jack, External Speaker Jack, Line Out, Output Tubes Matching, Return Level, Return Jack, Send Jack, Send Level, Reverb Out, Reverb In, Pedal Plain Jack, Pedal Red Jack, Hum Balance Adjust

CABINET 

SPEAKERS 

  • Size: 2 x 12
  • Impedance: 8 ohms
  • Model: Electro-Voice

TUBES

  • Pre amp: 7025
  • Power: 4 x 6L6
  • Bias: Fixed
  • Rectifier: Solid State
Back to FENDER FIELD GUIDE

18 comments

I am looking for an 1980’s super champ footswitch. you have one? Let me know please! Thank you, Frank

frank falduto,

Mike Xavier, have the original footswitch if you are still interested?

DONALD BARRY,

i have a 1983 fender super champ that was recently given to me as a gift. It sat in a closet since 83. I am looking for the proper footswitch for it. Anyone know where i can source one? serial #F221937

mike xavier,

Any guess on the value of one of these?

Jim,

Assuming that you or your Dad never changed the filter caps, That would be my first guess. They aren’t very expensive to replace. As someone else has suggested, amps can electrocute you, even if they’re not switched on. This is because capacitors store electricity and if you touch them or other components in the circuit even several days after you’ve unplugged the amp, they can discharge and literally kill you.

cigaro,

Leave a comment

Please note, comments need to be approved before they are published.