$5 Shipping on Orders Over $99
FENDER SUPER 112
1990-1992
Configuration: Head
Power: 60 Watts
Effects: Reverb
SCHEMATIC
LAYOUT
- Front Panel: In, In, Volume (Clean), Gain, Volume (Drive), Channel Switch, Treble, Middle, Bass, Reverb, Presence, Foot Switch In, Standby Switch, Power Switch, Pilot Light
- Back Panel: 8 Ohm Speaker Out, 4 Ohm Speaker Out, Line Out, Power Amp In, Pre Amp Out
CABINET
- Tolex: Black
- Grill Cloth: Dark Gray
- Logo: Grill Mounted, Raised, Chrome & Black Script
- Handle: Black Strap
- Feet: Chrome Glides
- Corners: Chrome Corners w/ Lip
- Knobs: Red or Black Pointer Knob, Unnumbered
- Hardware: Medium Chassis Straps 4 5/8''
SPEAKER
- Size: 1 x 12
- Impedance: 8 ohms
- Model: ?
24 comments
I want to recap mine so does anyone have a list of the caps I would need?
The Schematic states the 12at7 is the V103 Phase inverter, as is standard for a SR derived amp. The OD “channel” just engages V101b with a lower freq LP filter. I’ve compiled a bunch of mods on a Gdoc that I think would address all the Super 112 issues.
Tubes are 1x 12AT7 2x 12AX7 2x 6L6GC The info needs to be amended to show this. I just repaired one of these and they have a 12AT7 for the clean channel, 12AX7 for the dirty channel, and another 12AX7 for the Phase Inverter. Then 2 6L6 tubes.
Love mine but it takes a while to heat up. Doesn’t sound good cold. Heavy SOB, too, but once it’s hot, it rolls, baby.
when using the overdrive pull the notch filter and set it between 12 and 2 0’clock….makes ALL the difference.