FENDER PROSONIC
1996-2002
Configuration: Combo
Power: Switchable 30 Watts, 50 Watts, 60 Watts
Effects: Reverb
SCHEMATIC
LAYOUT
- Front Panel: In, In, Channel Switch, Volume, Gain 1, Gain 2, Treble, Bass, Middle, Master Volume, Reverb - Pilot Light
- Back Panel: Rectifier Switch, Power Switch, Standby Switch, External Speaker Jack, Foot Switch Jack
CABINET
- Dimensions: 18½ x 24 x 10½
- Tolex: Black, Snakeskin, Red, Sea-Foam Green, Lizard Skin
- Grill Cloth: Black / White / Silver
- Logo: Grill Mounted, Flat
- Handle: Black Strap
- Feet: Chrome Glides
- Corners: Chrome Corners w/ Lip
- Knobs: Black Chicken Head
- Hardware: Medium Chassis Straps 4 5/8''
SPEAKERS
- Size: 2x10 (8ohms each)
- Impedance: 16 ohms
- Model: Celestion
23 comments
Could you show the correct wiring diagram for the two 10in speakers in the Pro Sonic. I’m not getting much out of the game section at all and wonder if the wires where are installed improperly when someone put aftermarket speakers in it. I put the originals back in according to the way the wires were but not sure if they are correct. Thank you
This is good to read, Thank you. I am about to buy my friend’s Prosonic head, he bought it from Gary Hoey. ( has proof ), I have been reading all I can re: this amp. Your comments make me feel good! My plans for the amp are to use the clean channel, with pedals. That’s the way I run my ’87 Mesa Boogie Mark III, and, the way I run the amp you mentioned – Super Champ X2 ( head ), XLNT amp! It’s my new ‘church amp’, because it’s lighter than the Boogie ( duh ), anyway, the Normal Channel of the X2 is really really good IMO. I’m looking forward to the Pro Sonic, again, thanks for info, and, in my case, encouragement!
Keeping my Prosonics, but someone donated a Super Champ XD combo, which I loaded with a Raging Cajun speaker… whoaaa, portable power with a very, very nice tone indeed!