FENDER CHAMPION 600 REISSUE

FENDER CHAMPION 600 REISSUE

2006-2011 

Configuration: Combo
Power: 5 Watts
Effects: None

SCHEMATIC

LAYOUT

  • Back Panel: High In, Low In, Volume, Pilot Light, Power Switch

CABINET

  • Dimensions: 11" H X 12" W X 7.5" D
  • Tolex/Tweed: 1950's Two-Tone Brown and Blonde Vinyl Covering
  • Grill Cloth: Tan Chamois
  • Handle: Flat Brown Leather
  • Feet: Round Black Rubber
  • Knobs: Black Chicken Head

SPEAKER

  • Size: 1x6
  • Impedance: 4 ohms
  • Model: Fender Special Design Ceramic

TUBES

  • Pre amp: 1 X 12AX7
  • Power: 1 X 6V6GT
  • Bias: Cathode
  • Rectifier: Solid State
Back to FENDER FIELD GUIDE

4 comments

I bought my Champion 600 in 2008 (about). I put in a switchable tone-stack bypass, which was downright transformative, no pun. I found a mod online back then for giving it some overdrive, it helped a lot too. For the icing, I put in an ALNICO Weber 8 inch. I’ve been eternally impressed ever since. Oh yeah, I took out the negative feedback loop too.

Russ,

I just replaced the stock speaker with a Jensen Mod 6 ceramic speaker, it sounds better than the stock one, but would like to hear Weber Alnico, if anyone cares to respond! Also, I changed out the stock tubes, with a NOS JAN Phillips 6V6GT and a NOS RCA 12ax7a, and all these mods made the amp way, way, better now.

Terry Heavener,

I bought my Champion 600 in 2008 (about). I put in a switchable tone-stack bypass, which was downright transformative, no pun. I found a mod online back then for giving it some overdrive, it helped a lot too. For the icing, I put in an ALNICO Weber 8 inch. I’ve been eternally impressed ever since. Oh yeah, I took out the negative feedback loop too.

Russ,

I just replaced the stock speaker with a Jensen Mod 6 ceramic speaker, it sounds better than the stock one, but would like to hear Weber Alnico, if anyone cares to respond! Also, I changed out the stock tubes, with a NOS JAN Phillips 6V6GT and a NOS RCA 12ax7a, and all these mods made the amp way, way, better now.

Terry Heavener,

Leave a comment

Please note, comments need to be approved before they are published.