FENDER CHAMP 25 (25SE)

FENDER CHAMP 25 (25SE)

1992-1994 

Configuration: Combo
Power: 25 Watts
Effects: Reverb

SCHEMATIC

LAYOUT

  • Front Panel: "Normal" In, In, Treble, Middle, Bass, Mid Shift Switch - "Drive" Volume, Gain, Treble, Bass, Contour - Master Volume, Reverb - Effect Out, Effect In - Line Out - Standby Switch, Power Switch
  • Back Panel: Fuse

CABINET 

SPEAKER 

  • Size: 1 x 12
  • Impedance: 8 ohms
  • Model: 

TUBES

  • Pre amp: Solid State. A 12AX7 tube is listed on the schematic, but this is for a phase inverter.
  • Power: 2 x 6L6GC
  • Rectifier: Solid State

Comments: The SE model included a headphone jack and a channel/reverb footswitch The Effect Out, Effect In and Line Out jacks were on the front panel of the SE model only.

Back to FENDER FIELD GUIDE

13 comments

I tried one at a pawn shop. It was pretty trashed but sounded great. The guy would not budge off $300. I knew that was way to much. Two weeks later Guitar Center had one listed in their used gear section online. It cost me $241 ( with original foot switch) overnighted from NYC to the Colorado high country. This amp compares to my Peavey Delta Blues in terms of tone and ability to take pedals. She came with Chinese tubes that I swapped out for some JJ’s. The clean channel is transparent and smooth. Good clean headroom, although it lacks a little in the low end. The gain channel is a handful, but not completely useless. It has good 80’s Hair Metal tones. I tried this amp with all knobs set at 12 o’clock. It sounded decent and was a good starting point. I will be selling my V-32 combo. Thanks Guitar Center.

jabe dooley,

I agree with Swilly. This amp sounds just as good as any tube amp I’ve tried. It also sounds great with an acoustic pickup. It has a lot of low end response. Great amp, I’ll keep it!

Rex,

Absolutely LOVE the sound of this unit! Rich warm tones–highly under rated and under valued.

Swilly,

Leave a comment

Please note, comments need to be approved before they are published.