FENDER BLACKFACE PRO REVERB

FENDER BLACKFACE PRO REVERB

1965-1967

Configuration: Combo
Power: 40 Watts
Effects: Reverb, Tremolo

SCHEMATICS

LAYOUT

  • Front Panel: "Normal" In, In, Bright Switch, Volume, Treble, Bass - "Vibrato" In, In, Bright Switch, Volume, Treble, Bass, Reverb, Speed, Intensity, Pilot Light
  • Back Panel: AC Outlet, Polarity Switch, Fuse, Power Switch, Standby Switch, Speaker Jack, External Speaker Jack, Vibrato Jack, Reverb Jack, Reverb Out, Reverb In

CABINET

SPEAKERS

TUBES

  • Pre amp:
  • Power: 2 x 6L6GC
  • Bias: Fixed w/ bias adjustment pot.
  • Rectifier: GZ34 / 5AR4
Back to FENDER FIELD GUIDE

7 comments

i have a blackface pro reverb #on back is A 04850 what the year in it production #5

paul,

I am playing a 64 blackface pro with celestian cream speakers…delicious tone!

James,

My ’66 Pro Reverb is only 26″ wide, not 26 1/2″

Winnie Thomas,

I’m pretty sure Utah speakers were also used in Pro Reverbs in ’65…Pro Reverbs to me always had a ton of low end and is also a very loud amp. This was my initial impression. When I learned later that Pro Reverbs have the AA165 circuit (not the AB763) then it all made sense. The AA165 circuit is the circuit used in Bassman heads — which are also real loud and FULL of low end. The Pro Reverb is essentially a Bassman in a combo with reverb. Not as sweet sounding as the AB763 reverb combos, in my opinion, but a solid choice for loud Rock and Roll, just like a Bassman. Takes pedals great.

b1uesman44,

hi Bill, It is tempting to think the Bassman and the Pro Reverb are “the same circuit” because they carry the same aa1165 number. They are not. The AA1165 Pro circuit is significantly different from the AA1165 Bassman in several key areas. These differences are essential design changes that have a substantial and obviously audible effect on overall circuit performance. Some key differences are: 1.) rectifier/B+ supply. The aa1165 Pro is a GZ34 tube rectifier, while the aa1165 Bassman B+ is solid state. This means (among other things) a different mains transformer! 2.) The output transformer is substantially larger and is wound to a different ratio in a Bassman. Huge tonal difference here too 3.) The tone circuit voicing for the normal channel Pro and bass channel Bassman are vastly different. 4.) The stock vibrato circuit in a Pro substantially affects total circuit gain, compared to the normal channel of the Bassman. I agree with you, these are both great amps. However, based on these and other differences it is simply not accurate to say that he Pro is “…essentially a Bassman in a combo with reverb…” Unless you are also willing to say the same thing about any Fender with two 6L6 power tubes, 12AX7 preamp tubes, and fixed bias. Cheers! CBG

CoolBlueGlow,

Leave a comment

Please note, comments need to be approved before they are published.